Introduction

The 2.35 release addresses the bugs found in the WITE32 2.34 release and new features introduced after the WITE32 2.34 release. (This document uses the WITE32 2.34 release notes as a base line for comparison.)

Modifications:

The integral "Parametric" test outputs the PW50 result in both nanoseconds and microinches.

Test "MR transfer curve" outputs the coefficients of the approximation.

A new option "Abort immediately" has been added to the Production setup ("On runtime Failure" on the Grd/Norm tab). If selected the option causes the entire production to stop after the test running after the failed one.

A new option "Output Result When Tests Failed" has been added to the Production setup (on the Head S/N tab). If enabled the option causes the result of the MR Impedance test and the Head selection test to be sent out. The result names are:

MrImp for MR Impedance test
HdSel for Head Selection test
The possible values are:
0 - failure,
1 - success.

The WITE32 normalization subsystem has been modified so that it imports the data from the Wnorm.cnf file at the beginning of each Production run if the Wnorm.cnf file has been modified. It provides for a means of correcting the normalization coefficients outside WITE32.

Head Polarity test algorithm has been improved to provide for more robust polarity detection.

Fixed Bugs

The following bugs have been fixed:

If the same grade is used for both final grading and runtime grading and there are tests which fail the limits, the grading record appears twice in the final display. NOW: The duplicate record is removed from the grading display.

Known Bugs

All the recurring known bugs are reported on our web site, www.Guzik.com. If you encounter a problem that is not on that list, please report it to Guzik customer support at Support@Guzik.com.

There are no new known bugs in this release.